KNACRO Voltage Control Relay / Signal timing start / trigger timer / Auto 24V time delay relay / VT2.3 (DC 24V)

$8.80

  • Digital DC voltage detection, control relay outputs, limit 0-99.9V adjustable voltage can be set to exceed the upper limit relay can also be set below the lower limit of the relay can be detected as a voltage switch, battery over-voltage protection, discharge timing and so on.
  • Timer mode can set the relay contact close and release time, the implementation of a single timing loop.
  • In voltage control mode, it can preset upper and lower voltage values limits.
  • Set display shut, the minimum current values are 6mA/5V.
  • The pre-set parameters can be saved after power off.
Category:

Description

  • Digital DC voltage detection, control relay outputs, limit 0-99.9V adjustable voltage can be set to exceed the upper limit relay can also be set below the lower limit of the relay can be detected as a voltage switch, battery over-voltage protection, discharge timing and so on.
  • Timer mode can set the relay contact close and release time, the implementation of a single timing loop.
  • In voltage control mode, it can preset upper and lower voltage values limits.
  • Set display shut, the minimum current values are 6mA/5V.
  • The pre-set parameters can be saved after power off.
 Timing Range: 0-999 seconds or 0-999 minutes.
Voltmeter display range: DC 0-99.9 V.
Voltage detection error: ± 0.1V.
Operating Power: DC 5~9V.
Relay parameters: *Coil Voltage: DC 5V.
A set of conversion (Open and Close).
Contact load: 10A/277V AC or 10A/30V DC.
Contact resistance: ≤ 100mΩ (1A 6VDC).
Mechanical durability: 10 millions.
Electricity durability: > 100,000 (10A-250VAC).
Operating Temperature: -40 ~ 85 degree.
External signal input: 5 to 12V or passive switch.
Size:108*50*20mm.
Weight:55g.
Operating modes:
P-1: Timer.
P-2: Delay timer.
P-3: Voltage control relay, on and off control.
P-4: Voltage control Timer- A (Close).
P-5: Voltage control Timer- B (Release).
P-6: Voltage range control relay.
P-7: Voltage range control Timer.
P-8: Set display shut.
Attention:
Do not reverse input voltage polarity!
Use this product to control the high-voltage electrical equipment
must electrical professionals to operate,high voltage danger!
Wiring must be operated at a power-off state.Package Included:
1 KNACRO Voltage Control Relay / Signal timing start / trigger timer / Auto 5V time delay relay / VT2.3
1 User manual

Reviews

There are no reviews yet.

Be the first to review “KNACRO Voltage Control Relay / Signal timing start / trigger timer / Auto 24V time delay relay / VT2.3 (DC 24V)”

Your email address will not be published. Required fields are marked *